Tall round resin display plinths, cast in strong and stable black pigmented resin. Every effort has been taken to remove bubbles, after casting each plinth has been machined to ensure the top and bottom surfaces are parallel and true. I inspect each plinth and fill and sand any imperfections, although sometimes I miss things.
The four largest sizes have been designed to be hollow. This saves not only to save resin but to allow ease of shipping the product. A wide rim 10 - 15 mm rim has been left to allow somewhere to drill for transportation magnets (not supplied)
Sizes I am currently producing are 110mm, 100mm, 80mm, 60mm, 50mm and 40mm in diameter. The finished height is approximately 65mm once machined (this height can vary plinth to plinth) The 80mm plinths finish taller at 75mm but can be requested to be produced at 65mm if desired.
PRODUCTION - PLEASE READ!
Due to the amount of resin required to produce these plinths they will be cast to order. This can mean a lead time of up to a week dependant on quantities. I would always recommend ordering ahead of time if you require them for a competition. I will always strive to cast items immediately and aim to get orders out the next day.
Your plinths may arrive in a sanded and prepared state, each and every plinth I cast is meticulously inspected for imperfections these are then filled and sanded out.
Prior to use it is recommended to clean each piece is warm soapy water to remove residue release agent. Persistent release and silicone residue will remove with spirit based fluid, I recommend white spirit and an old tooth brush. Wash in water after using spirit based cleaners. If any small bubbles are present they can be filled with superglue applied from a pin tip and sanded back. I would always recommend spraying your plinth in a flat coat of black to even out the colour.